I think I had done something specific on that page [either a combination of doing autosort with some other things] to make the page unhappy. I copied the data I cared about to a fresh page and had no problem. Too bad I don't know exactly what I did to cause the irregulariity.
On 8/13/05, Doug Thompson <[EMAIL PROTECTED]> wrote: > > You can probably safely ignore this earlier reply. I've now had a > second cup of coffee, read it again, and can see it doesn't answer the > question. > > Whether your problem it is a bug in OOo is determined by if it can be > reproduced on another system. I can't do it here using either 1.9.122 > or 1.1.4 on W98, don't recall ever seeing something like it, and > conclude that OOo isn't the cause but rather a vehicle to expose the > symptom. > > I suggest you start with running the installation program again. This > time select "Repair". If that doesn't correct the behavior, the next > stage is to Remove and Re-install OOo. If you haven't de-fragged your > disk drive for awhile, do that in between the Removal and re-installation. > > In general, problems of this type are caused by the specific computer > system and are not errors in OOo. If it were a problem in OOo, then > lots of users would be reporting it. > DT > > Doug Thompson wrote: > > David Rudel wrote: > > > >> I have a curious problem, and i was wondering if it is a bug or if > >> there is something extra I need to do. It is more a nuisance than a > >> major problem. > >> I often have two Calc documents open at once. One document has a list > >> of important information, which I can then cut and paste where needed > >> in the other document. > >> I have noticed that when I switch from one document to the other and > >> click on a cell, the outline normally does not appear. I can still do > >> the cut and paste, but the cells I select do not shadow as I select > >> them, so I have to be careful to make sure I am dragging my cursor > >> over the correct cells. > >> Is this a known issue? Is there something specific I have to do to > >> tell Calc that I really want it to consider the other document the > >> active page? > >> [I searched the knowledge base, but I was unable to find anything > >> related.] > >> Thanks! > >> -David > >> > > Whether or not the grid lines are displayed is a document property which > > is saved with the document. You apparently turned off the grid lines in > > one document. You will find the setting for this feature under > > Tools > Options > OpenOffice.org Calc > View > > > > Doug > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] > > For additional commands, e-mail: [EMAIL PROTECTED] > > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > >
