Greetings; While I've been here a while, on general principles, I'm by no means a guru about OOo. So please bear with an old fart for a couple of paragraphs.
My wife just handed me a penciled up drawing of a bowling scorecard, to be used up at one page per line bowled. Asked me to scan & copy it, but even in greyscale from the scanner, its still about 10 minutes a page to print from the gimp. Not exactly 'by the ream' production rate that. Plug in the poor quality of reproduced pencil lines and you get the picture that I'm not proud of the result. This sheet is a very simple thing needing (in landscape mode) 3 full bleed horizontal lines, and about 11 full bleed vertical lines & 11 short lines to break up each frames per ball scores. And about 60 characters of text in various locations. I think I can draw the lines in writer, ISTR I've done that before, so I don't think thats a problem. So the question then is: How do I set writer to compose and display in landscape mode rather than portrait so that text entry is also in landscape mode? -- Cheers, Gene People having trouble with vz bouncing email to me should add the word 'online' between the 'verizon', and the dot which bypasses vz's stupid bounce rules. I do use spamassassin too. :-) Yahoo.com and AOL/TW attorneys please note, additions to the above message by Gene Heskett are: Copyright 2005 by Maurice Eugene Heskett, all rights reserved. --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
