OK, so they're not big woes...
Trying to make a single sheet of labels with the same addressee. I know
I can create a label, select a label style or create a new one, type in
an address and select to print an entire sheet (none of this is terribly
intuitive, but I found the options eventually).
What I can't seem to do is go back and edit the structure of the label
after it's created. I'm using a margin-less and gutter-less 30-Up label
(Avery 5354) which I had to create. Then, after selecting this type and
typing in the address, I created it forgetting to select to create an
entire sheet of this address. I could find no way to go back and
correct my mistake without creating a new label sheet. Luckily the
address and my new label type were all selected, so it wasn't hard to
do. Is there a way to go back and edit these options after creating a
label page?
Then, after creating the sheet properly, I found that the margins were
not quite right (OOo put the text to the far left whereas I wanted the
text to be more centered left-to-right and top-to-bottom). I tried to
modify the first label as needed, but those changes didn't get applied
to the rest of the labels on the page. I then tried to select all the
labels on the page and set paragraph indents and spacing above
paragraphs to acheive what I wanted, but this changed the entire label
spacing such that three columns no longer fit within my page size, so
the third label wrapped to the next line. Obviously not what I want.
I'm pretty sure in 1.04 there was a way to make modifications to the
label output such that things like margins within a label and text
attributes (e.g. font size) would be applied to the entire sheet. I'm
interested in how others do this.
Carl (XP, 2.0.3)
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
