On 02/27/2012 06:34 PM, Dan Yasny wrote:
----- Original Message -----
From: "Nathan Stratton"<[email protected]>
To: "Dan Yasny"<[email protected]>
Cc: [email protected], "Andrew Cathrow"<[email protected]>
Sent: Monday, 27 February, 2012 4:13:54 PM
Subject: Re: [Users] Using virsh on the node
On Mon, 27 Feb 2012, Dan Yasny wrote:
So the engine is a VM in that same cluster, along with the VMs it
manages?
Yes, the only thing I have not been able to figure out is how to let
the
ovirt-engine know that ovirt-engine is running. :) I thought that it
would
see via libvirt, but it does not. I also tried setting it in the db,
but
it keeps getting cleared. Any idea on how to let ovirt-engine know
that a
host has been started manually?
Seriously, not a good idea. The Engine is supposed to be looking at the setup,
and not be in the setup, where it may be affected by the problems that might
occur to the setup.
I'm pretty sure there's lots of though being devoted to removing this
limitation, but when we say it's a bad idea, it really is, it's not like we
simply want you to run an extra machine
Doron - this reminds me of the all-in-one discussion. what was the
resolution on flagging the node as a node running an engine VM (even
without engine knowing about its own VM)
What do you use for storage?
That's easier than block storage, but still, what happens if the host where the
engine was running failed - who would update VM statuses and restart the HA VMs?
NFS:
mount 10.13.0.4:/images/ /rhev/data-center/mnt/10.13.0.4:_images
mount 10.13.0.4:/iso/ /rhev/data-center/mnt/10.13.0.4:_iso
Dan Yasny
Red Hat Israel
+972 9769 2280
<>
Nathan Stratton CTO, BlinkMind, Inc.
nathan at robotics.net nathan at
blinkmind.com
http://www.robotics.net
http://www.blinkmind.com
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
