On 22/01/14 12:13, Dan Kenigsberg wrote:
On Wed, Jan 22, 2014 at 07:43:52AM +0000, Karli Sjöberg wrote:
On Tue, 2014-01-21 at 21:22 -0300, Federico Sayd wrote:
Hello:
I am having problems with bonding
I have installed Centos 6.5 in order to use it as host. I configured
eth0 with the vlan of the management network (Vlan 70). Then I
registered the host to the engine (3.3.2-1-el6) and the engine
installed oVirt in the host without problem. Ovirtmgmt was created
automatically and bridged with eth0.70.
Now I need to bond a second network interface (eth1) with eth0. But
when I try to bond the nics, I get the next error:
"A slave interface is not properly configured. Please verify slaves do
not contain any of the following properties: network name, boot
protocol, IP address, netmask, gateway or vlan-ID notation (as part of
interface's name or explicitly)"
Federico, where exactly do you get this error? Would you attach the
setupNetwork log from supervdsmd.log?
I get the error in the setup-network dialog in ovirt-engine.
Today I solved the issue copying the network config of other host (same
hardware), and it worked.
The supervdsm.log whith the lines logged yesterday:
http://pastebin.com/kpXrRd2w
It would be nice if the error could be more explicit, i.e. telling the
ifcfg-* that are conflictive.
Thanks
I delete any unnecessary parameters from ifcfg-eth0 and ifcfg-eth1.
This is my network config:
ifcfg-eth0:
DEVICE=eth0
TYPE=Ethernet
ONBOOT=yes
ifcfg-eth1:
DEVIC E=eth1
TYPE=Ethernet
ONBOOT=yes
ifcfg-eth0.70:
# Generated by VDSM version 4.13.2-1.el6
DEVICE=eth0.70
ONBOOT=yes
VLAN=yes
BRIDGE=ovirtmgmt
NM_CONTROLLED=no
STP=no
ifcfg-ovirtmgmt:
# Generated by VDSM version 4.13.2-1.el6
DEVICE=ovirtmgmt
ONBOOT=yes
TYPE=Bridge
DELAY=0
IPADDR=192.168.1.101
NETMASK=255.255.255.0
BOOTPROTO=none
DEFROUTE=yes
NM_CONTROLLED=no
STP=no
No others ifcfg-* files.
I don't see the parameters that oVirt doesn't like. Any clue,
workaround, bug report....?
Thanks!
Federico
PD: Sorry for my basic english
I´ve seen issues from folks trying to configure Host network through
webadmin and failing one too many times now, so I decided to write
something up:
http://www.ovirt.org/Bonding_VLAN_Bridge
Hope this helps!
Thanks Karli! Though it SHOULD be possible to start with eth0 and eth0.2
on the host (where "2" is the vlan id of your manamgement network), and
from there on, do all configuration via Engine.
I'd like to automate as much as possible out of this process, and iron
out remaining bugs. Hence, I would like to hear more about Federico's
mode of failure.
One comment to your wiki page: in order to better intergrate with our
recent source-routing support (mostly useful for display network),
please set GATEWAY only in ifcfg-ovirtmgmt, and remember to set
DEFROUTE=no in any other ifcfg that mentions IPADDR so as not to
override the default.
Dan.
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
