On 05/26/2014 04:15 AM, Fabian Deutsch wrote:
Am Sonntag, den 25.05.2014, 09:01 -0400 schrieb Doron Fediuck:
Don't we have ovirtmgmt defined by default
during the registration process?
Hey,
IIRC that is done by ovirt-host-deploy during the registration, yes.
- fabian
----- Forwarded Message -----
From: "Jorick Astrego" <[email protected]>
To: "users" <[email protected]>
Sent: Monday, May 19, 2014 1:11:58 PM
Subject: [ovirt-users] workflow node installation
Hi,
I don't know if I'm doing things wrong but the workflow for node installation
is a bit cumbersome for me.
The things I have to do to get a node up in ovirt engine:
- install node image from pxe
- approve node
- put node into maintenance mode (storage not available)
- Setup Host Networks
- Sync network (otherwise I cannot save the network changes)
- Setup Host Networks again
- Save Network setup
- activate node
This seems problematic to me -- the host networks should be
automatically set when you approve the node joining a given cluster.
Are you setting up the host networks on the engine side, or do you have
to approve, log back into the node, configure networking, etc?
And this I have to do for every node. It could save me some time if I could
setup the networks on approval or engine puts it directly into maintenance
mode without the sync requirement.
Kind regards,
Jorick Astrego
Netbulae B.V.
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
