On 05/27/2014 06:25 PM, Ryan Barry wrote:
On 05/26/2014 04:15 AM, Fabian Deutsch wrote:
Am Sonntag, den 25.05.2014, 09:01 -0400 schrieb Doron Fediuck:
Don't we have ovirtmgmt defined by default
during the registration process?
Hey,
IIRC that is done by ovirt-host-deploy during the registration, yes.
- fabian
----- Forwarded Message -----
From: "Jorick Astrego" <[email protected]>
To: "users" <[email protected]>
Sent: Monday, May 19, 2014 1:11:58 PM
Subject: [ovirt-users] workflow node installation
Hi,
I don't know if I'm doing things wrong but the workflow for node
installation
is a bit cumbersome for me.
The things I have to do to get a node up in ovirt engine:
- install node image from pxe
- approve node
- put node into maintenance mode (storage not available)
- Setup Host Networks
- Sync network (otherwise I cannot save the network changes)
- Setup Host Networks again
- Save Network setup
- activate node
This seems problematic to me -- the host networks should be
automatically set when you approve the node joining a given cluster.
Are you setting up the host networks on the engine side, or do you have
to approve, log back into the node, configure networking, etc?
Everything from the engine side, we would like to deploy all the servers
without manual intervention as much as possible so we don't have to
login to the nodes at all. Preferably we disable local login completely
for security purposes. ovirtmgmt works fine but I have two iSCSI
networks and a separate internet network that are all set to required
network.
And this I have to do for every node. It could save me some time if
I could
setup the networks on approval or engine puts it directly into
maintenance
mode without the sync requirement.
Kind regards,
Jorick Astrego
Netbulae B.V.
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
