Den 5 jul 2014 05:06 skrev Dwight Schauer <[email protected]>: > > Hello oVirt users, > > I'm running into network setup problems. > > http://www.ovirt.org/Vdsm_Network > > Shows this as a supported topology. > > bridge1 --- v1 --- bond --- nic1 > bridge2 --- v2 --/ \-- nic2 > > Problem is I have to configure at least this on each host in order to the > connect to an activate: > > v1 --- bond --- nic1 > \-- nic2 > > Which oVirt does not like because I already created the bond and attached a > vlan interface to it. > > So I configured this ahead of time (without vdsm) > > bridge1 --- v1 --- bond --- nic1 > bridge2 --- v2 --/ \-- nic2 > > Those work fine. I can use each bridge statically or with DHCP. > > Problem is that oVirt refuses to use the bridge interfaces (they don't show > up in the web gui), it only wants to use the bond interface. > > If I was using libvirt/kvm-manager I would preconfigure this (without vdsm): > > bridge1 --- v1 --- bond --- nic1 > bridge2 --- v2 --/ \-- nic2 > > And I'm be able to run VMs on other VLAN. (Which is what I want to achieve > with oVirt). > > Is there a way I can achieve what I need to do (connecting VMs to either > VLAN) with one of my preconfigured setups without resorting to another nic > (or bonded pair?) > > -- > Dwight >
Have you restarted the "vdsmd" ? /K _______________________________________________ > Users mailing list > [email protected] > http://lists.ovirt.org/mailman/listinfo/users
_______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
