On Mon, 2014-07-07 at 10:52 +0100, Dan Kenigsberg wrote: > On Sat, Jul 05, 2014 at 03:05:51AM +0000, Dwight Schauer wrote: > > Which oVirt does not like because I already created the bond and attached a > > vlan interface to it. > > What do you mean by "not like"? If v1 has an IP address attached to it, > you should be able to add this host to an oVirt cluster.
By "not like" I mean I can try to configure oVirt networking but it won't work with the way I had it set up. > I would not recommend this, but you could define a libvirt network per > bridge to make it show in the web gui: > <network> > <name>vdsm-bridge1</name> > <forward mode='bridge'/> > <bridge name='bridge1' /> > </network> Thanks. I don't think I'll need to use that since I've found that if I use an initial vlan interface with an id I won't be using in the oVirt networking setup then I don't run into problems. While I need to have some initial network pre-configuration, I've found out who to do it in a way that oVirt will accept and work with. -- Dwight _______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
