Hi, here it goes:
ethtool -i eth3
driver: bnx2
version: 2.2.4g
firmware-version: bc 5.2.3
bus-info: 0000:06:00.1
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: no
On 07-10-2014 21:57, Federico Simoncelli wrote:
----- Original Message -----
From: "Ricardo Esteves" <ricardo.m.este...@gmail.com>
To: "Federico Simoncelli" <fsimo...@redhat.com>
Cc: users@ovirt.org
Sent: Tuesday, October 7, 2014 8:44:19 PM
Subject: Re: [ovirt-users] oVirt 3.2 - iSCSI offload (broadcom - bnx2i)
cat /var/lib/iscsi/ifaces/eth3
# BEGIN RECORD 6.2.0-873.10.el6
iface.iscsi_ifacename = eth3
iface.transport_name = tcp
iface.vlan_id = 0
iface.vlan_priority = 0
iface.iface_num = 0
iface.mtu = 0
iface.port = 0
# END RECORD
Is there anyway to tell ovirt to use bnx2i instead of tcp?
Hi Ricardo, can you paste the output of:
# ethtool -i eth3
Thanks,
_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users
