Hello,
I am hoping someone here has had experience in setting up an iSCSI
target using 'targetcli'. I followed the following guide:
<http://www.certdepot.net/rhel7-configure-iscsi-target-initiator-persistently/>. This is on my single host (with hosted engine currently running; I am using a seperate HDD for the iSCSI
storage)
The iSCSI initiator of my host, from it's information page in oVirt,
is <iqn.1994-05.com.redhat:ba4cc8b3368e>, so I created an ACL with
that name. Here is a result of the listing in the 'acls' directory
for my IQN:
--- START ---
/iscsi/iqn.20...gt1/tpg1/acls> ls
o- acls ..............................................................
[ACLs: 1]
o- iqn.1994-05.com.redhat:ba4cc8b3368e ......................
[Mapped LUNs: 1]
| o- mapped_lun0 .................................... [lun0
block/block1 (rw)]
--- END ---
So it appears as though my host's initiator is mapped to my LUN 0.
When I go in to oVirt and add iSCSI storage, the "Discover" finds my
target, and I can even log in successfully, however when I click on
the "LUNS->Targets" side tab, there are no LUNs listed, so I cannot
add any iSCSI storage.
Any ideas on why the LUN is not showing up?
Thanks! :-)
Regards,
Alan
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
