I am trying to run the command qpidd install however the broker only starts and no service appears in services.msc any suggestions ?
On Fri, Nov 30, 2012 at 2:18 PM, Rajesh Khan <[email protected]>wrote: > I am using version 0.18 > > > On Fri, Nov 30, 2012 at 2:16 PM, Steve Huston <[email protected]>wrote: > >> Sorry, I responded without carefully reading all of it. >> >> You can put the options in qpidd.conf or put "--auth no" in the command >> line args to pass to the service when started. However, Darryl's question >> is important - what version? The command line passing feature works in the >> Qpid 0.18 installer from Riverace.com and it works in the current >> development stream. >> >> -Steve >> >> > -----Original Message----- >> > From: Rajesh Khan [mailto:[email protected]] >> > Sent: Friday, November 30, 2012 4:02 PM >> > To: [email protected] >> > Subject: Cannot run broker as a daemon >> > >> > I am trying to run qpid broker as a daemon by following the >> instructions in >> > the Manual. I am doing the following >> > >> > D:\...\src\Debug>qpidd --daemon >> > 2012-11-30 13:58:17 [Broker] critical Unexpected error: Error in >> command line >> > options: unknown option daemonUse --help to see valid options >> > >> > It seems --daemon parameter is not valid. How do I run the broker as a >> > daemon. >> > I know i can run it as a service by installing it. How can I run it as >> a service with >> > the --auth=no parameter >> >> --------------------------------------------------------------------- >> To unsubscribe, e-mail: [email protected] >> For additional commands, e-mail: [email protected] >> >> >
