On 03/26/2014 03:10 PM, Andrew Stitcher wrote:
On Wed, 2014-03-26 at 10:58 -0400, Andrew Stitcher wrote:
On Wed, 2014-03-26 at 11:39 +0000, Gordon Sim wrote:
...
Using the CMAKE_PREFIX_PATH doesn't work for me either. Pointing it at
the latest 0.7rc3 installation gives:
CMake Warning at src/amqp.cmake:22 (find_package):
Could not find a configuration file for package "Proton" that is compatible
with requested version "0.5".
The following configuration files were considered but not accepted:
/home/gordon/qpid-releases/proton/0.7rc1/installation/lib64/proton.cmake/proton-config.cmake,
version: 0.7
This is a leftover from a pre 0.7 build and is confusing the detection.
If you remove the install area completely and make install proton again
it should work. I don't think the file proton-config.cmake made it into
a proton release so there should only be a small number of people
affected by this problem.
Let me know if this didn't fix the problem and I will look at it some
more.
I just realised that it is possible my changes to proton went in *after*
rc1. In which case 0.28 will not work with it, as the changes to proton
and qpid need to be in step. As Rafi didn't tag the release candidate I
can't easily tell from source control.
My changes went into proton at r1577978 which was the change after the
version number bump.
If that is correct you will need to use trunk proton until rc2.
What about the pkg-config based build? I thought you said that would
still work? It doesn't seem to.
Are you saying that 0.28 will only build against proton trunk, not
against 0.5 and 0.6 as it did before? If so that seems an unnecessary
restriction to me.
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
