On 07/15/2014 06:51 AM, zhengxie wrote:
Hi,
I have some problems about qpid dynamic route. I am using quid 0.28 on
linux 2.6.
The problem is like this:
I want to configure a dynamic route among host A, B, C like this :
A<=>B<=>C, I suppose message sent to A should be received in C, however,
the result is not, I can only receive on B. However, if I open 3 ports on
one host, each instance on each port, the result is what I supposed to be.
This is how I configure on one host, my 3 hosts is 10.1.253.203,
10.1.253.230, 10.1.252.165. (below is abbreviate)
qpid-route dynamic add 203 230 amq.direct
qpid-route dynamic add 230 203 amq.direct
qpid-route dynamic add 230 165 amq.direct
qpid-route dynamic add 165 230 amq.direct
This is how I test:
qpid-send -b 10.1.253.203 -a amq.direct/key230 --content-string
"Hi,key230"
--durable no
qpid-receive -b 10.1.252.165 -a amq.direct/key230 --timeout 200
(no result)
Is there something wrong? I hunger for your answer. Thanks!
This is probably a stupid question, but just to confirm, you are
starting qpid-receive before qpid-send right? And allowing a little time
for the subscription to propagate?
There routes you set up above are as they should be.
Are there any errors in the broker logs (especially B and C? Can you
receive at C if you send to B (instead of A)?
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
