On Tue, 2014-07-15 at 16:47 +0800, 郑勰 wrote: > Hi， > I have fixed this problem a few minutes ago, I must start qpidd with > --auth no, although -auto no is default, it does seem not effect, if > without —auth no, type link list showing that B->C is not > connected.
Actually the default is auth=yes, so that would explain the problem. > > > 郑勰 > > > > > > > > > > 大数据产品部-商业智能中心-产品研发部 > > > > > > 亚信科技（中国）有限公司 > > > > > > 手机：186-1233-5012 > > 邮箱：[email protected] > > 地址：北京市海淀区西北旺东路10号院东区亚信总部研发中心大厦 > > 邮编：100085 > > > > > > > > 在 2014年7月15日，下午4:37，Gordon Sim <[email protected]> 写道： > > > On 07/15/2014 06:51 AM, zhengxie wrote: > > > Hi, > > > > > > I have some problems about qpid dynamic route. I am using quid > > > 0.28 on > > > linux 2.6. > > > > > > The problem is like this: > > > > > > I want to configure a dynamic route among host A, B, C like > > > this : > > > A<=>B<=>C, I suppose message sent to A should be received in C, > > > however, > > > the result is not, I can only receive on B. However, if I open > > > 3 ports on > > > one host, each instance on each port, the result is what I > > > supposed to be. > > > > > > This is how I configure on one host, my 3 hosts is 10.1.253.203, > > > 10.1.253.230, 10.1.252.165. (below is abbreviate) > > > > > > qpid-route dynamic add 203 230 amq.direct > > > qpid-route dynamic add 230 203 amq.direct > > > qpid-route dynamic add 230 165 amq.direct > > > qpid-route dynamic add 165 230 amq.direct > > > > > > This is how I test: > > > > > > qpid-send -b 10.1.253.203 -a amq.direct/key230 --content-string > > > "Hi,key230" > > > --durable no > > > > > > qpid-receive -b 10.1.252.165 -a amq.direct/key230 --timeout 200 > > > (no result) > > > > > > Is there something wrong? I hunger for your answer. Thanks! > > > > This is probably a stupid question, but just to confirm, you are > > starting qpid-receive before qpid-send right? And allowing a little > > time for the subscription to propagate? > > > > There routes you set up above are as they should be. > > > > Are there any errors in the broker logs (especially B and C? Can you > > receive at C if you send to B (instead of A)? > > > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [email protected] > > For additional commands, e-mail: [email protected] > > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
