On 09/11/2014 08:32 PM, Justin Ross wrote:
Hi, everyone. The 0.30 release candidate is now available:
https://dist.apache.org/repos/dist/dev/qpid/0.30-rc/
Maven repos for qpid-java and qpid-java-qmf-tools respectively:
https://repository.apache.org/content/repositories/orgapacheqpid-1012
https://repository.apache.org/content/repositories/orgapacheqpid-1013
Take notice! This remains pre-release software. Use it only for testing.
http://people.apache.org/~jross/qpid-0.30-rc.log
There's been quite a bit of good testing and feedback so far. Thanks very
much to those who have helped. My testing on Fedora 19 x86-64 showed no
test failures (though it does show some test clean up issues). Please test
the RC in your own environment and report back to this list.
These artifacts are signed. If approved by vote, the RC bits will be the
GA bits. I plan to open the vote Tuesday next week if no new blockers are
discovered in the mean time.
Now that we've begun to produce release candidates, only "blocker" issues
will be considered for inclusion. See the release page for more
information.
I've gone through some basic testing on all the packages:
* qpid-cpp builds and tests pass (couple of expected failures due to
missing dependencies)
* python tests pass against c++ broker (qpid-python, qpid-tests)
* c++ client works over 0-10 and 1.0 against c++ broker
* qpid tools work against broker (qpid-python, qpid-qmf, qpid-tools)
* JMS Drain works against c++ broker
* the qpid-java-qmf-tools stuff builds ok; the scripts didn't work 'out
of the box for me' I had to setup a classpath manually and was then able
to run QpidConfig and also the REST management service
* qpid-java builds and runs internal tests ok
* ran JMS client (0-10 only) against c++ broker
* had to dig around to find how to start the broker from this package,
but did eventually get it going
* c++ clients can send and receive ok over 0-10 and 1.0
* out of the box broker only supports CRAM-MD5, which the python client
doesn't support. I changed the broker to allow anonymous and tests ran
with one failure:
qpid_tests.broker_0_10.dtx.DtxTests.test_set_timeout_too_high raised
error 'Xid already started an neither join nor resume setXid(format=0,
globalId="dummy", branchId="v24")'
Nothing I would consider a blocker.
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
