Tested qpid-cpp-0.30.tar.gz on windows and everything works as expected. Built 64-bit broker/clients/dotnet_binding and they all interoperate.
----- Original Message ----- > From: "Gordon Sim" <[email protected]> > To: [email protected] > Sent: Friday, September 12, 2014 12:55:39 PM > Subject: Re: 0.30 release update - Release candidate > > On 09/11/2014 08:32 PM, Justin Ross wrote: > > Hi, everyone. The 0.30 release candidate is now available: > > > > https://dist.apache.org/repos/dist/dev/qpid/0.30-rc/ > > > > Maven repos for qpid-java and qpid-java-qmf-tools respectively: > > > > https://repository.apache.org/content/repositories/orgapacheqpid-1012 > > https://repository.apache.org/content/repositories/orgapacheqpid-1013 > > > > Take notice! This remains pre-release software. Use it only for testing. > > > > http://people.apache.org/~jross/qpid-0.30-rc.log > > > > There's been quite a bit of good testing and feedback so far. Thanks very > > much to those who have helped. My testing on Fedora 19 x86-64 showed no > > test failures (though it does show some test clean up issues). Please test > > the RC in your own environment and report back to this list. > > > > These artifacts are signed. If approved by vote, the RC bits will be the > > GA bits. I plan to open the vote Tuesday next week if no new blockers are > > discovered in the mean time. > > > > Now that we've begun to produce release candidates, only "blocker" issues > > will be considered for inclusion. See the release page for more > > information. > > I've gone through some basic testing on all the packages: > > * qpid-cpp builds and tests pass (couple of expected failures due to > missing dependencies) > * python tests pass against c++ broker (qpid-python, qpid-tests) > * c++ client works over 0-10 and 1.0 against c++ broker > * qpid tools work against broker (qpid-python, qpid-qmf, qpid-tools) > * JMS Drain works against c++ broker > > * the qpid-java-qmf-tools stuff builds ok; the scripts didn't work 'out > of the box for me' I had to setup a classpath manually and was then able > to run QpidConfig and also the REST management service > > * qpid-java builds and runs internal tests ok > * ran JMS client (0-10 only) against c++ broker > * had to dig around to find how to start the broker from this package, > but did eventually get it going > * c++ clients can send and receive ok over 0-10 and 1.0 > * out of the box broker only supports CRAM-MD5, which the python client > doesn't support. I changed the broker to allow anonymous and tests ran > with one failure: > qpid_tests.broker_0_10.dtx.DtxTests.test_set_timeout_too_high raised > error 'Xid already started an neither join nor resume setXid(format=0, > globalId="dummy", branchId="v24")' > > Nothing I would consider a blocker. > > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
