Hi Andreas, Thank you for reply. I'm not using command line Uniflash (unable to setup on Win10, any good guide?), so flashing with GUI version. With a first board I really don't know why program was not executing after launchpad power-cycle. Doing the same operations with another launchpad - no problem. Any suggestion regarding "Keep CCFG data" in Uniflash GUI under Settings & Utilities, should I check/uncheck it? FYI: Later the first board I bricked by checking box "Binary" in Uniflash, same problem is described in TI forum https://e2e.ti.com/support/wireless_connectivity/low_power_rf_tools/f/155/p/551375/2024942#pi239031350=1
Best Regards, amid 2018-01-10 20:24 GMT+02:00 Andreas "Paul" Pauli < [email protected]>: > Hi amid, > > Am 06.01.2018 um 21:55 schrieb amid: > >> However another problem I have. Once I power cycle the board (reset >> button or re-attach USB) no leds blink / UART output, so I need to flash >> the binary again. Why it is happening? >> > > I have checked with my launchpad and the LEDs are blinking after a reset > as well as removing power for ~1 minute. > I have no clue what might be the issue on your system. > > regards > Paul >
_______________________________________________ users mailing list [email protected] https://lists.riot-os.org/mailman/listinfo/users
