Update to my last email. Once I flashed RIOT tests_leds.hex to cc265-launchpad with Flash Programmer 2, program execution doesn't start. Then I flashed same hex with Uniflash and behavior described before (program executes once after flashing, but not executing after board power-cycle) reproduced. Maybe someone else could reproduce and clarify what is happening?
BR, amid 2018-01-10 22:52 GMT+02:00 amid <[email protected]>: > Hi Andreas, > Thank you for reply. > I'm not using command line Uniflash (unable to setup on Win10, any good > guide?), so flashing with GUI version. With a first board I really don't > know why program was not executing after launchpad power-cycle. Doing the > same operations with another launchpad - no problem. > Any suggestion regarding "Keep CCFG data" in Uniflash GUI under Settings & > Utilities, should I check/uncheck it? > FYI: Later the first board I bricked by checking box "Binary" in Uniflash, > same problem is described in TI forum > https://e2e.ti.com/support/wireless_connectivity/low_ > power_rf_tools/f/155/p/551375/2024942#pi239031350=1 > > Best Regards, > amid > > 2018-01-10 20:24 GMT+02:00 Andreas "Paul" Pauli < > [email protected]>: > >> Hi amid, >> >> Am 06.01.2018 um 21:55 schrieb amid: >> >>> However another problem I have. Once I power cycle the board (reset >>> button or re-attach USB) no leds blink / UART output, so I need to flash >>> the binary again. Why it is happening? >>> >> >> I have checked with my launchpad and the LEDs are blinking after a reset >> as well as removing power for ~1 minute. >> I have no clue what might be the issue on your system. >> >> regards >> Paul >> > >
_______________________________________________ users mailing list [email protected] https://lists.riot-os.org/mailman/listinfo/users
