Standard Ettus image Cheers!
Maria Jesús On Wed, Mar 20, 2019, 5:15 PM Marcus D. Leech <[email protected]> wrote: > On 03/20/2019 01:12 PM, Mª Jesús Cañavate Sánchez wrote: > > Hi Marcus, > > No, it is the same for both. I don't know if there is a way to reactivate > them or if suddenly they just don't work anymore. > > Best regards, > > María Jesús > > Are you running custom FPGA firmware, or a standard Ettus image? > > > > On Wed, Mar 20, 2019, 5:09 PM Marcus D. Leech via USRP-users < > [email protected]> wrote: > >> On 03/20/2019 11:37 AM, Maria Jesus Cañavate Sanchez via USRP-users wrote: >> > Hi there, >> > >> > Last week I was able to work normally on my USRP X-310 but when I >> > tried to use it again this week the Ethernet connection was not >> > working anymore. The LEDs are actually off so the Ethernet connection >> > cannot be detected on a switch or a PC. Do you know what the problem >> > could be? I have used different Ethernet cables and have checked that >> > the Ethernet adapter (SFP) works perfectly in another device so it >> > must be a problem related to the USRP itself. >> > >> > What do you think I should do? Should I use the JTAG interface to >> > configure anything? Is there a way to reset the USRP from the hardware >> > or JTAG? >> > >> > Thank you very much in advance! >> > >> > Best regards, >> > >> > Maria Jesus >> What about the 2nd SFP port--does it show any signs of life? >> >> >> >> _______________________________________________ >> USRP-users mailing list >> [email protected] >> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com >> > >
_______________________________________________ USRP-users mailing list [email protected] http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
