On 03/20/2019 01:17 PM, Mª Jesús Cañavate Sánchez wrote:
Standard Ettus image
Cheers!
Maria Jesús
There's some guidance here on using the JTAG USB port to program a fresh
image into the FPGA. That might help:
https://files.ettus.com/manual/page_usrp_x3x0.html#x3x0_jtag
On Wed, Mar 20, 2019, 5:15 PM Marcus D. Leech <[email protected]
<mailto:[email protected]>> wrote:
On 03/20/2019 01:12 PM, Mª Jesús Cañavate Sánchez wrote:
Hi Marcus,
No, it is the same for both. I don't know if there is a way to
reactivate them or if suddenly they just don't work anymore.
Best regards,
María Jesús
Are you running custom FPGA firmware, or a standard Ettus image?
On Wed, Mar 20, 2019, 5:09 PM Marcus D. Leech via USRP-users
<[email protected] <mailto:[email protected]>>
wrote:
On 03/20/2019 11:37 AM, Maria Jesus Cañavate Sanchez via
USRP-users wrote:
> Hi there,
>
> Last week I was able to work normally on my USRP X-310 but
when I
> tried to use it again this week the Ethernet connection was
not
> working anymore. The LEDs are actually off so the Ethernet
connection
> cannot be detected on a switch or a PC. Do you know what
the problem
> could be? I have used different Ethernet cables and have
checked that
> the Ethernet adapter (SFP) works perfectly in another
device so it
> must be a problem related to the USRP itself.
>
> What do you think I should do? Should I use the JTAG
interface to
> configure anything? Is there a way to reset the USRP from
the hardware
> or JTAG?
>
> Thank you very much in advance!
>
> Best regards,
>
> Maria Jesus
What about the 2nd SFP port--does it show any signs of life?
_______________________________________________
USRP-users mailing list
[email protected] <mailto:[email protected]>
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
_______________________________________________
USRP-users mailing list
[email protected]
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
