This doesn't sound like a good idea to me. On Thu, May 6, 2021 at 11:26 PM Zeng, Huacheng <[email protected]> wrote:
> Dear Rob and Marcus, > > Thank you for your response. I have a follow up question. Since I do not > have an RF power splitter at hand for the external LO source, do you think > it is fine to use a 1-to-2 SMA cable to connect an N210's output port to > N310's TX and RX External LO ports? Thanks again. > > Best regards, > Hua > > > > On Thu, May 6, 2021 at 10:58 PM Marcus D Leech <[email protected]> > wrote: > >> This should work. Keep in mind that the mixers in the N310 are 2XLO so >> the external LO has to be at twice the desired tuned frequency. >> >> Sent from my iPhone >> >> > On May 6, 2021, at 10:31 PM, Zeng, Huacheng <[email protected]> >> wrote: >> > >> > >> > Hello, >> > >> > I want to use an external LO for N310. I learned that a common case is >> to use a signal generator to produce the external LO and feed it to N310. >> Since I do not have a signal generator at the moment, I was wondering if it >> is okay to use an N210 to generate the external LO for N310. I will adjust >> the Tx gain of N210 so that the output power is in the range of 0 to 6 dBm. >> > >> > Regards, >> > Hua >> > _______________________________________________ >> > USRP-users mailing list -- [email protected] >> > To unsubscribe send an email to [email protected] >> > _______________________________________________ > USRP-users mailing list -- [email protected] > To unsubscribe send an email to [email protected] >
_______________________________________________ USRP-users mailing list -- [email protected] To unsubscribe send an email to [email protected]
