I recently went through the same thing. I got the race and needle bearing
out but the outer sleeve would not budge. I finally had a guy at the local
performance shop cut it out with a pneumatic cutting wheel.
Bryan - VMOA #706
http://test.militarypals.com/eden/
----- Original Message -----
From: steven detamore <[EMAIL PROTECTED]>
To: V-MAX TECH LIST <[EMAIL PROTECTED]>
Sent: Tuesday, April 25, 2000 8:52 PM
Subject: rear wheel bearings
> having a problem getting a purchase on the inside of the
> cyllendrical bearing (drive side) to knock it out. those four openings in
> the seat don't let you get much of anything on the bearing radius. any
> suggestions? thanks.......steve #1131
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com
>
> .............................................
> To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
> .............................................
>
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
