Steve,
I made a tool when I had the same problem. I could send you a picture and
dimensions if you like. Or you could borrow it for cost of postage.
Dave Galusha
VMOA 1177
----- Original Message -----
From: steven detamore <[EMAIL PROTECTED]>
To: V-MAX TECH LIST <[EMAIL PROTECTED]>
Sent: Tuesday, April 25, 2000 6:52 PM
Subject: rear wheel bearings
> having a problem getting a purchase on the inside of the
> cyllendrical bearing (drive side) to knock it out. those four openings in
> the seat don't let you get much of anything on the bearing radius. any
> suggestions? thanks.......steve #1131
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com
>
> .............................................
> To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
> .............................................
>
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
