Ya you should DOCUMENT this.
I will need this information then it won't be there for me
to find then I will blame
you (TC) cause you didn't document it somewhere for me to
find and use.
I will also blame Paul for not putting it somewhere..
But I will not except the responsabality to put this info
somewhere myself.
So put it somewhere. ( No not there)
:-)
TC wrote:
> Janne,You need to adjust the mixture screw on this
> cylinder, (#3) .. if it does not respond then blow these
> things out .. (pilots) .. (do it anyhow). We probably need
> to document this procedure and post it somewhere because
> it is a biggie .... After you "blow" them out, (compressed
> air into the pilot mixture screw or one of the pilot air
> jet holes), see if you can get the cylinder to respond to
> adjustments of it's pilot mixture screw ... If not, (do it
> anyhow), sync your carbs because the throttle plate is
> probably completely closed. IMHO ....campbell--
Bob
[EMAIL PROTECTED]
Middleburg Fl (South Jacksonville)
ICQ 13912841
VMOA's New SWAP BUY SELL Board @
http://www.InsideTheWeb.com/mbs.cgi/mb611473
CBMMA #4
1977 XS750D 1J7008405
1997 Vmax12J VMOA #504
Ham Radio Call: KR4DA
Web Page
http://home.earthlink.net/~kr4da
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
