blair
if your talking about a floor jack i think you'll
need two people and a couple of jack stands as well.
i'd imagine you can do it alone but it's too dangerous.
you basically use the jack stand and find a spot under
the engine between the pipes and carefully lift it up.
you may need a small block of wood or something to
get better clearance from the pipes. then you put
a jack stand under each side on the part of the frame
near the rear foot pegs....
good luck and be careful.
d
> Blair Yeager wrote:
>
> Can anyone tell me how to properly support the Vmax using a hydraulic
> lift. I have never used one, but it appears I will need to modify the
> supports to somehow grab the frame without crushing the head pipes. Am
> I way off? , Kerker 4 2 1 on the bike, no center stand.
>
> thanks,
> Blair Yeager
--
Doug Ullman
RF Communications Group
Level One Communications
an Intel Company
916.855.5177 x2298
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
