Al, what did you use to shim mounts? I noticed some gaps when installing
mine and was a bit concerned about it.
Randy Nial
95' Vmax VMOA #814
Ft. Laud.,FL USA
[EMAIL PROTECTED]
----- Original Message -----
From: AL Hasapis <[EMAIL PROTECTED]>
I did shim my
> mounts to eliminate any gaps that existed between the
> mounts and the engine bosses when installed. I shimmed
> for the following gaps, I found on my installation.
> FWD. L/H lower .019, L/H top-(none .000).
> FWD. R/H top .075. FWD R/H lower .003.
> Both aft mounts .010. Wondering Has anyone else
> experienced this? Regards...AL H.
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
