Don, is right, I had the same problem, after ruening
the screw heads, the only tool that worked for me was
a pair of vise grips. good luck Al H.
--- Dusty <[EMAIL PROTECTED]> wrote:
> Hi Gang,
> I just got a CarbTune II and am going to balance the
> carbs. - I'm sure they
> need it.
> The previous owner thought that the throttle adj was
> one of the sync
> screws...
> I had set it by ear.
> Anyway, now the carb joint covers have Philips head
> screws that are tight, I
> can't seem to get them to budge without damaging the
> screw head. Has anyone
> had to get medieval on these screws and replace
> them?
> Any tricks to get them to budge, hot vs cold engine,
> oil, sledgehammer &
> chisel?
> Thanx,
> Dusty
> VMOA #1305 - '97 Platinum
> http://www.netace.com/vmax
> Tampa, Florida
>
>
> ..............................................
> To unsubscribe go to
> http://www.sayegh.org/unsubscribe.htm
> ..............................................
__________________________________________________
Do You Yahoo!?
Send instant messages & get email alerts with Yahoo! Messenger.
http://im.yahoo.com/
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
