on 10/23/00 6:27 PM, Eric Harnish at [EMAIL PROTECTED] wrote:
>> I'm going to have you take a look at the calipers . Take a feeler gage
>> set and check the clearence
>> between the pistons and the brake pad backing plates. These clearences
>> must be equall on all
>> four pads . If they are out, shim to equalize . This will cause the
>> master cyl. to travel to far before the
>> pads will fully engage the rotor . I've been there before . Try it &
> let
>> me know .
>> Hope it helps .
>> Eric H.
Eric,
These clearances should be self-adjusting. The only way there should be
appreciable difference is if a piston seal is binding, holding the piston
away from the pad.
best,
Sat Tara
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
