There is a spring loaded curved washer that you can
uses that will "Spring Load" the bolt and will serve
to apply pressure against the head and keep it in
check. Also you should use a type of loctite that is
resistant to breakdown of the oil it is exposed to.
Dave
--- dinah <[EMAIL PROTECTED]> wrote:
> after removing my flywheel I noticed the only
> problem I fould was
> the three bolts where worn an loose.
> is there any trick to keep the new bolts tight other
> than loctite, or
> is loctite good enough ??
> thanks for any advise
> Bob
> Wilson # 1324
>
> .............................................
> To unsubscribe go to
> http://www.sayegh.org/unsubscribe.htm
> .............................................
__________________________________________________
Do You Yahoo!?
Thousands of Stores. Millions of Products. All in one Place.
http://shopping.yahoo.com/
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
