Vmaxer, Well .. good luck .. these are beautiful systems. The header by itself would cost you $500 ... They are stainless steel and very light ... They are low so you have to watch out ... it is not impossible to dent the front down pipes ...... If it only has a "scrape" it will polish out ..... Stainless will turn amber as you use it but polishes right back up ..... If your dropping your forks through .. or planning to get "low" .. this probably isn't the pipe ... (or any hindle variant) .... IMHO as always ...... campbell ----- Original Message ----- From: [EMAIL PROTECTED] To: V-MAX TECH LIST Sent: Monday, November 13, 2000 8:21 PM Subject: More info on the Two Brothers exhaust Campbel the Exhaust is new in box at a dealership lower tube has small scrape was installed on a 1999 last fall customer didnt expect clerance troubles and complained it was too loud it was removed in one week. I have concerns about installation time dealer said 7 hours called Two brothers they say 3hrs tops plus rejeting carbs 1-2hrs. I see in old letters that most people get exhaust on in only a couple hours this is where I think a dealership wants to make the money back (I plan to do the instal myself, cousin jet the carbs and dyno tune) So for now I offerd the owner 250 see if he wants to get rid of it. Vmaxer ............................................. To unsubscribe go to http://www.sayegh.org/unsubscribe.htm .............................................
