If you decide to use aluminum instead I would use a
high strength alum such as 6061-T6
Stainless is a lot heavier. The brace will only be
required to sure up, or trush up the forks and
stainless is not necessary.
Guedo
me 2 centavos
--- Tan Hang Siah <[EMAIL PROTECTED]> wrote:
> Hi,can anyone tell me,in term of effectiveness,is
> there any different
> between a fork brace which is made from stainless
> steel and that made from
> aluminium?I had a friend made one from stainless
> steel but one of the screw
> hole is out of alignment so he is going to made
> another one with the
> original brace as measurement and is it all right to
> have framebrace to be
> made from a 1 ins hollow stainless steel?
> All instruction and opinion is very much appreciated
> Thank you
__________________________________________________
Do You Yahoo!?
Yahoo! Shopping - Thousands of Stores. Millions of Products.
http://shopping.yahoo.com/
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
