Set screws of all sizes can be had at most any good hardware... in this area , the
service desk at a decent Ace Hardware would be the place to go... Bring the handle
with you. Installing a separate "close" handle might be the answer to pulling the
handle off...( Rivet it to the Door) I went through a lock replacement last year and
the Tri-Mark lock I wound up with has a pretty good handle built into the side of the
lock (inside)... I would think a separate handle could be fashioned that would look
like it belonged there....
Jim
04/12/2001 9:26:56 AM, [EMAIL PROTECTED] wrote:
>I have a '74 Trade Wind that has the cast aluminum interior handle. Due to
>useage by people who weren't overly familiar with the trailer's
>idiosyncracies when closing the door from the inside, the handle has come
>off the shaft and the set screw has been lost. We have had to resort to
>using a pair of vice grips on the interior.
To unsubscribe or to change to a daily Digest, please go to
http://www.airstream.net/vaclist/listoffice.html
If replying back to this message, please delete all the unnecessary original
text from your reply.
