|
Thanks for the info. What would the standard
replacement be and what does it cost?
Thanks
-Tim
----- Original Message -----
Sent: Saturday, July 07, 2001 4:20
AM
Subject: [VAC] Re: Uni Volt
In a message dated
7/6/2001 2:26:11 PM Central Daylight Time,
[EMAIL PROTECTED] writes:
How much voltage should a uni-volt put out when removed from the
trailer,
sitting on the bench with nothing connected?
Mine is
putting out around 8.5v.
Thanks
If I
recall correctly it should be around 1 volts. The Univolt is set at
about 13.2 on a fully charged deep cycle battery instead of the 13.6 on a
regular auto battery. I had a schematic faxed from the univolt
manufacturer,
but it was not the correct one even when I had the model
number and serial.
The large SCR in the Univolt is not
available anymore, and a comparable one
is about $50. I replaced it
with another curcuit, and had some trouble
adjusting the voltage
correctly. Sooooo I replaced it with one of those
rebuilt convertors
that have been discussed here, and use my old univolt as a
battery charger
on the trucks in our fleet. It works great!!!
Cecil in OKla
Check out www.cowboyforpresident.com
|
