I recently added a third budget card to my VDR which contained 2 budgets
pointing at Astra so far (using softdevice for decoding): 

00:0a.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
00:0f.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)

00:0a.0 Class 0480: 1131:7146 (rev 01)
00:0f.0 Class 0480: 1131:7146 (rev 01)

/var/log/messages says
DVB: registering new adapter (Fujitsu Siemens Activy Budget-S PCI (rev 
GR/grundig frontend)).
DVB: registering new adapter (TT-Budget/WinTV-NOVA-CI PCI).

During my first runs I had connected the third LNB to one of the budgets
by just moving one sat cable to the new LNB. I could watch all channels
from Astra and Hotbird O.K. The SkyStar2 was not connected so far.

Now adding the SkyStar2 card:

00:0b.0 Class 0280: 13d0:2103 (rev 01)
00:0b.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip 
/ Technisat SkyStar2 DVB card (rev 01)

DVB: registering new adapter (FlexCop Digital TV device).

This card is connected to a LNB pointing at Hotbird. dvbscan shows all the
channels on the respecive cards just fine. I generated the channels.conf
listing using dvbscan. 

But from then on, I could either see the Astra channels or the Hotbird
channels within VDR, never both sets at the same time.  It appears as
if only card #0 is active (the Activy card), no matter which LNB is
connected to which budget card. 

What am I missing? As far as I know there is no way (and no point)
in telling VDR to use cards #0 and #1 for Astra and #2 for Hotbird. Is
that a known problem between (certain versions of) budget/-ci and b2c2
cards / drivers?


dvb-1.1.0_CVS20051019-17 (OpenSUSE 10.1) in kernel
softdevice-0.3.1 w/ ffmpeg-0.4.9 / DirectFB- / DFB++-0.9.25 / 

Any hint is appreciated! 

Every nonzero finite dimensional inner product space has an orthonormal basis.

It makes sense, when you don't think about it.

vdr mailing list

Reply via email to