[ sorry for breaking thread - but people don't seem to honor CC ]
On 04/08/08 22:49, Klaus Schmidinger wrote:
> > And explanation:
> > After a reset CAM is "absent" for a very short time (<14ms == less than
> > a scheduler tick) and then it takes ~1.7s to become ready again. (The
> > intervall between reset and status query seems to be a bit bigger in vdr
> > - so we only see the 3-->1 change == 3-->2 in vdr numbers).
> > It's an endless loop: cam detection --> cam reset --> cam not
> > present/ready for a short while --> vdr thinks cam has been physically
> > removed --> cam detection --> cam reset etc.
> > Big thanks to Christoph for assistance.
> > Is it realistic to hope for a workaround/solution for this kind of CAMs
> > (Technotrend CX at my case)?
> Since this apparently happens also without VDR, I guess it will have to
> be fixed in the driver.
No. If you issue a reset, you have to deal with its consequences. And
one obvious consequence is that the cam is unusable for a certain time
(and thus reports not-ready).
vdr mailing list