Thanks, do you have his address. Mike Robinson
Clover, SC 29710 > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of Desert Eagle > Sent: Sunday, February 10, 2002 5:19 PM > To: [EMAIL PROTECTED] > Subject: Re: [VFB] RE: bamboo rod restorers > > > Send it to Tony Spezio, only answer. > Jimi > > > Need some help. Need to find a shop to store an antique bamboo flyrod > around Roanoak, Va. > Any suggestions or recomendations. > > Thanks, > > Mike Robinson > Clover, SC 29710 > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED]]On Behalf Of Ed Roden > > Sent: Sunday, February 10, 2002 8:35 AM > > To: [EMAIL PROTECTED] > > Subject: RE: [VFB] Vinyl Rib Material > > > > > > Thanks Bob and Matt! I got it after some experimenting. I was > > tying in the > > ribbing across the hook shank to give it some more body. Tying it in so > > that the flat side was down, and very carefully putting it > there forced it > > to give me the round side up while wrapping. > > > > Ed Roden > > Quest for Quality Computers, Inc. > > "Any BYTE-sized Job" > > [EMAIL PROTECTED] > > http://www.questquality.com > > > > If you're too open minded, your brains will fall out. > > > > > -----Original Message----- > > > From: [EMAIL PROTECTED] > > > [mailto:[EMAIL PROTECTED]]On Behalf Of Matt Fleming > > > Sent: Saturday, February 09, 2002 6:43 PM > > > To: [EMAIL PROTECTED] > > > Subject: Re: [VFB] Vinyl Rib Material > > > > > > > > > Ed, the easiest way is to tie it in with the round side towards > > > the hook when tied in and tied a slight angle "down." When you > > > wrap it it "folds" over and with the round side up. dont feel > > > bad, it took me a while to get it too :-) If you want the flat > > > side up, tie in with flat side towards the hook. Hope this helps > > > a little, Matt > > > -----Original Message----- > > > From: "Ed Roden"<[EMAIL PROTECTED]> > > > To: [EMAIL PROTECTED] > > > Date: Sat Feb 09 15:34:45 PST 2002 > > > Subject: [VFB] Vinyl Rib Material > > > > > > >Here's a question for you - how do you get vinyl rib > material to always > > > >start wrapping with the rounded side up? I've gotten lucky on > > > several, but > > > >frustrated on a few others. It adds neat different effects by > > having the > > > >flat side up, but if that isn't what I'm going for... > > > > > > > >Ed Roden > > > >Quest for Quality Computers, Inc. > > > >"Any BYTE-sized Job" > > > >[EMAIL PROTECTED] > > > >http://www.questquality.com > > > > > > > >If you're too open minded, your brains will fall out. > > > > > > > > > > > > > ___________________________________________________ > > > GO.com Mail > > > Get Your Free, Private E-mail at http://mail.go.com > > > > > > > > > > > > > > > >
