Are you sure the readings are correct, and that your caliper did not flatten the thread? Maybe checking the thread on the unlabeled spools against labeled thread under a magnifier will be more accurate.
Martin
---
George Vincent wrote:
Most of the labels have long since fallen off my spools of thread, but I have for the most part been able to keep them separated size. Lately some of the spools were in bobbins have been replaced and bottom line is I can no longer tell what size thread some of the spools contain.
I dug out the faithful calipers that I used to reload rifle cartridges and came up with the following: UNI Thread 6/0 = 0.02 UNI Thread 8/0 = 0.01 Flymaster 210 = 0.02 Flymaster Plus = 0.02 Danville Size A = 0.02 Monocord = 0.02
Does anyone have a better way of determining thread size?
George
================================================================ Deze e-mail is door E-mail VirusScanner van Planet Internet gecontroleerd op virussen. Op http://www.planet.nl/evs staat een verwijzing naar de actuele lijst waar op wordt gecontroleerd.
