Date: Fri, 4 Feb 2005 07:03:43 -0500 From: [EMAIL PROTECTED] (Hal Meeks) Subject: FWB Jackhammer SCSI card questions
Hi all,
I just installed a Jackhammer SCSI card (with version 3.2 control panel) and connected the internal 50pin hard drive to it. It boots OK with the internal drive but whenever I try to connect an external device I get a sad Mac. Is this normal or have I not installed something properly? Thanks!
The NuBus JackHammer uses actual physical termination resistors which must be removed or replaced to change the JackHammer's termination configuration. If you have a 50 pin internal drive connected and a 68 pin or 50 pin (through adapter) external drive connected then you need to remove two of the termination resistor packs and leave the third one (labeled Term 16) installed.
Jeff Walther
-- Vintage Macs is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Enter To Win A | -- Canon PowerShot Digital Cameras start at $299 | Free iBook! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
Vintage Macs list info: <http://lowendmac.com/lists/vintagemacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[email protected]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/vintage.macs%40mail.maclaunch.com/>
iPod Accessories for Less at 1-800-iPOD.COM Fast Delivery, Low Price, Good Deal www.1800ipod.com
