i made up a kit. 2 pipe taps,drill,air fitting to screw into block and housing to put on end of air hose,drill and all. want to borrow kit?
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dean Johnson Sent: Monday, August 27, 2012 4:14 PM To: Air-Cooled Volkswagen Discussion List Subject: Re: [vintagvw] Hello, I'm back. Bill, First, its good to see you still on the list, I remember getting a lot of solid information from you. Did you use a 37/64 and a tapered reamer, or did you drill out 9/16ths. I ordered the full flow kit and instructions from Gene Berg so I suppose I should wait for the instructions, But I wouldn't know where to get a 37/64th bit or a reamer, home heating supply store?. If I had a truck I'd just take the engine to a machine shop but... So I'm hoping a 9/16ths will do it. I guess I'd just have a bigger hunk of material to remove at the start of the hole. Thanks, Dean On Mon, Aug 27, 2012 at 10:37 AM, bill may <[email protected]> wrote: > you can drill and tap while engine is assembled. gene berg did an > article on it. i have done it following his instructions. > > -----Original Message Deleted----- > _______________________________________________ vintagvw site list [email protected] http://lists.sjsu.edu/mailman/listinfo/vintagvw _______________________________________________ vintagvw site list [email protected] http://lists.sjsu.edu/mailman/listinfo/vintagvw
