With your console started, what does it show in the console log? (e.g.
"CP SPOOL CONSOLE * START NAME WAKEUP TEST").
You can also add at near the top of your exec the line (after the: /* */ )
the command:
trace I
that will show exec executed REXX line, and the spooled console (which
will go to your reader when you LOGOFF or issue 'CP SPOOL CONSOLE CLOSE'
will show what happened. Use "RDRLIST" and "PEEK" to view it (tip: before
using PEEK, set it to show all the lines, not just the first 200 lines, by
entering: "DEFAULTS SET PEEK FROM 1 FOR *")
Mike Walter
Hewitt Associates
The opinions expressed herein are mine alone, not my employer's.
"Vince" <[EMAIL PROTECTED]>
Sent by: "VM/ESA and z/VM Discussions" <[email protected]>
12/28/2005 04:17 PM
Please respond to
"VM/ESA and z/VM Discussions" <[email protected]>
To
[email protected]
cc
Subject
Re: NEW to Z/VM WAKEUP
Bob and Rich Thanks very much for your replies. I tried both
suggestions and neither worked for me. I must have something else
wrong. Vince...
The information contained in this e-mail and any accompanying documents may
contain information that is confidential or otherwise protected from
disclosure. If you are not the intended recipient of this message, or if this
message has been addressed to you in error, please immediately alert the sender
by reply e-mail and then delete this message, including any attachments. Any
dissemination, distribution or other use of the contents of this message by
anyone other than the intended recipient is strictly prohibited.
