Hi Stephen,

the response to display devstate e40 is before and after activating the
ETH1XCA majornode the same: "Filename: /dev/net1 State: OPEN". There comes
no error messages on the flexes console.

Franz Josef
----- Original Message ----- 
From: "Stephen Frazier" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Thursday, February 16, 2006 11:57 PM
Subject: Re: [VMESA-L] problem with vm vtam on tserver


> Enter the CLI command "display devstate e40" to flexes.
>
> [EMAIL PROTECTED] wrote:
>
> > Hi listers,
> >
> > I cannot get my ethernet adapter to work. If I activate it it gets a
sense
> > 081c0000
> > IST093I ETH1XCA ACTIVE
> > IST380I ERROR FOR ID = L0E40000 - REQUEST: ACTLINK, SENSE: 081C0000
> >
>
> > These are the relevant tserver's flex-es config statements (Flex-es v7)
> >
> > channel(0) local              # channel 0 a local channel
> >
> > cu devad(0xE40,1)   path(0) resource(cuSNAa)   # xca For sna
> >
> > cuSNAa: cu osasna               # zVM Virtual CTC to local 3172 on Eth
SNA
> >    interface local(1)
> >    options 'adapternumber=1'
> >    device(00) osasna /dev/net1    # Ethernet Adapter
> >    end cuSNAa
> >
> > This is the ifconfig -a output to document that the adapters are not
used by
> > unixware
> >
> > lo0: flags=4049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
> >         inet 127.0.0.1 netmask ff000000
> >         inet/perf: recv size: 4096; send size: 8192; full-size frames: 1
> >         inet/options: rfc1323
> > net0: flags=4043<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
> >         inet 192.168.0.50 netmask ffffff00 broadcast 192.168.0.255
> >         inet/perf: recv size: 24576; send size: 24576; full-size frames:
1
> >         inet/options: rfc1323
> >         ether 00:09:6b:b0:5f:ca
> >
> > My tcpip connection on /dev/net2 is working well.
> >
> > The ethernet adapter is a dual port intel pro/100 as you can order with
the
> > tserver. On the apar database I had already found an apar VM61479 which
> > pointed to the same error message but it did not help. There is no error
> > message on the flex console when activating the device. I have also
tested
> > with cu type xcasna. It got the same result.
> >
> > Can anybody give me an idea what I still can do to get the sna
connection
> > working.
> >
> > Mit freundlichen Grüßen / best regards
> >
> > Franz Josef Pohlen
>
> -- 
> Stephen Frazier
> Information Technology Unit
> Oklahoma Department of Corrections
> 3400 Martin Luther King
> Oklahoma City, Ok, 73111-4298
> Tel.: (405) 425-2549
> Fax: (405) 425-2554
> Pager: (405) 690-1828
> email:  stevef%doc.state.ok.us
>
>

Reply via email to