In a message sent earlier today Dan Sugalski had asked
about not accepting the defaults during a configure.com
run. Here was an attempt to build with RC3:
----------------------------------------------
During the configure I specify to accept the default types
----------------------------------------------
This is currently broken in some configurations. Only enable it if
you know what you're doing.
Always use default file types? [N] y
----------------------------------------------
The later on the build bombs at the usual place:
----------------------------------------------
Link /NoTrace/NoMap/NoDebug/Trace/NoMap/NoFull/NoCross/Exe=SYS$DISK:[]MINIPERL.E
XE miniperlmain.obj, libperl.olb/Library/Include=globals ,[]crtl.opt/Options
MCR Sys$Disk:[]miniperl.exe "-I[.lib]" [.VMS]Writemain.pl "DynaLoader Socket"
Fatal VMS error (status=114762) at DKB100:[PERL-5_6_0-RC3]VMS.C;1, line 4674.
%RMS-E-DNF, directory not found
-NONAME-W-NOMSG, Message number 00000000
%MMS-F-ABORT, For target PERLMAIN.C, CLI returned abort status: %X0001C04A.
-RMS-E-DNF, directory not found
----------------------------------------------
Peter Prymmer
