:) -----Original Message----- From: Alex Morris [mailto:[EMAIL PROTECTED]] Sent: Tuesday, December 10, 2002 10:27 AM To: VNC List Subject: Re: Only able to view, not interact
Er, ignore me, folks. I've been stupid. *cough* I had changed the InputsEnabled bit, in MACHINE.INI, from 1 to 0. Time to go hang my head in shame. -- Alex Morris ------- Forwarded message follows ------- >I've been using Richard Harris' excellent Fastpush script >(http://www.darkage.co.uk) to punt VNC out to some remote Windows NT >machines at work with, so far, no problems until today. > >The flavour of VNC I've been deploying is TightVNC 1.26. I've been >deploying it to two specific machines and removing it again once I've >finished remotely controlling them. > >Last week, yesterday and this morning all was working just fine. This >afternoon I can connect to the two remote machines with the TightVNC >viewer but can only view what's going on. I can't interact with the >machines at all. Even Send CTRL+ALT+DEL has no effect. > >Stripping out and reinstalling VNC (via the script) has no effect, >either. Upon reconnection I'm still limited to just viewing what's at >the other end. > >I doubt very much that the Fastpush script is causing the problem. I >suspect the problem is with TightVNC, either at my end with the viewer >or at the other end with the server, yet I'm at a loss to work out >what. The script I used today is the same as it was when I used it >yesterday, and last week. I've not changed it beyond my original >modifications (setting the environment variables). > >Can anyone offer any suggestions? _______________________________________________ VNC-List mailing list [EMAIL PROTECTED] http://www.realvnc.com/mailman/listinfo/vnc-list _______________________________________________ VNC-List mailing list [EMAIL PROTECTED] http://www.realvnc.com/mailman/listinfo/vnc-list
