Jeff,
I am at a command prompt and to exit the telnet session I simply type exit.
The vncserver is still running (or appears to be) and I verified this by closing the
vncviewer that goes gray and then opening it again. Someone told me that I might have
to remove/reinstall vncserver as root so it sets itself up as a daemon but it should
have done that when I initially installed that as a sysadmin.
Sincerely,
Matthew C. Agle - MCP, MCSA
Technical Specialist - Desktop Support
FANUC Robotics Information System Department
Phone: 1-248-276-4256
Fax: 1-866-743-2586
Email: [EMAIL PROTECTED]
-----Original Message-----
From: Jeff Boerio [mailto:[EMAIL PROTECTED]
Sent: Monday, January 05, 2004 7:19 PM
To: Agle, Matthew
Subject: Re: question regarding realvnc for unix (sol 9)
Matthew,
Is the vncserver script exiting? In other words, when you try to log
out from your telnet session, are you at a command prompt? Or, do you
need to take some relatively drastic action in order to get back to a
command prompt?
- Jeff
On Mon, 2004-01-05 at 12:43, Agle, Matthew wrote:
> Hello,
>
>
>
> In regards to running vnc, I am experiencing a issue and
> wondered if anyone has seen this/fixed this issue as well. The problem
> I am having is as follows:
>
>
>
> I am currently running a sparc ultra station 5 with solaris 9 and the
> latest cluster patches. I have downloaded and installed the latest vnc
> software package and configured it to run CDE/Enlightenment as a GUI
> that I often use with a Windows XP SP1A machine. The problem I have is
> this; I telnet into my Solaris box, start vnc by issuing the command
> vncserver and then from Windows I use vncviewer to open the screen. It
> opens the display and starts the GUI fine and everything seems to work
> ok however when I go back and kill my telnet session to my box, the vnc
> screen goes gray and the desktop is no longer accessible. I am not sure
> how to resolve this and any insight would be greatly appreciated!
> Thanks to any/all who reply!
>
>
>
>
>
> Sincerely,
>
>
>
> Matthew C. Agle - MCP, MCSA
>
> Technical Specialist - Desktop Support
>
> FANUC Robotics Information System Department
>
> Phone: 1-248-276-4256
>
> Fax: 1-866-743-2586
>
> Email: [EMAIL PROTECTED]
> <mailto:[EMAIL PROTECTED]>
> _______________________________________________
> VNC-List mailing list
> [EMAIL PROTECTED]
> To remove yourself from the list visit:
> http://www.realvnc.com/mailman/listinfo/vnc-list
_______________________________________________
VNC-List mailing list
[EMAIL PROTECTED]
To remove yourself from the list visit:
http://www.realvnc.com/mailman/listinfo/vnc-list
