I have a problem where hovering over the vnc icon on the task bar doent display the ip address. This is a isolated problem as I have vnc installed on quite a few machines. I know I can get the ip address other ways but this is sometimes difficult to explain to users. Is there a setting that I need to configure to make the ip pop up when hovering over the icon?
Thanks Lee Redden Tel:01924 836911 Ext 111 E-mail: [EMAIL PROTECTED] ************************************************************************ ******************* William Lamb Footwear Limited Registered office: Bottomboat Road, Stanley, Wakefield WF3 4AY Registered in England Number 2513251 This email is only intended for the person(s) to whom it is addressed. Unless stated to the contrary, any opinions or comments are personal to the writer and do not represent the official view of the company. It may not be disclosed or used by anyone other than the addressee, nor may it be copied in any way. If received in error, please notify [EMAIL PROTECTED] quoting the name of the sender and then delete from your system. Please note that although this mail item has been checked by virus software, William Lamb Footwear cannot accept any responsibility for any transmitted viruses. It is, therefore, your responsibility to scan attachments (if any). Thank you for your co-operation. ----------------------------------------------------------------------------- ------- scanned for viruses and unwanted content by emailsystems Information regarding this service can be found at www.emailsystems.com _______________________________________________ VNC-List mailing list [email protected] To remove yourself from the list visit: http://www.realvnc.com/mailman/listinfo/vnc-list
