I went through the calibration process today, using the manual and my 'new' Fluke 5100B. I made a 'short circuit plug' by connecting 'HI' to 'LO' only. All was OK until the last step of 'CALIBRATE REFERENCE'. I kept getting 'FACTOR OUT OF RANGE'. What am I missing?
However, after checking it against my other, Ametek calibrated, 7081, the readings on the various scales are very close, about 10 uV at 10 VDC, for instance, and 2 mV at 10 VAC using a 1 kHz signal and about 36 ohms at 1 MegOhm. This is a significant improvement from where it started. Thanks for any help. Joe _______________________________________________ volt-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.
