I have access to a metrology lab with a Fluke 5522A, and a 8508A. Any hints regarding what should be checked (more thoroughly)?
Regards, Gabi On 1/19/2015 10:57 PM, Laurence Motteram wrote:
An external calibration may help, as (usually/optionally) the internal calibration source is characterized at the end of the calibration process. If you have the equipment to do so, it would be good to verify that there is not something more sinister going on with the 100mV and 1V ranges other than simple drift. Best Regards, Laurence Motteram -----Original Message----- From: volt-nuts [mailto:[email protected]] On Behalf Of MailLists Sent: Tuesday, 20 January 2015 6:53 AM To: [email protected] Subject: [volt-nuts] Datron 1281 Dear all, got one of the (in)famous <subj.>. The full self-test fails with: 2273 1V Range 100mV signal magnitude drift. 2283 100mV Range 100mV signal magnitude drift. The same for a self-calibration. Any suggestions? Might an external calibration help? Probably not calibrated for a long time... Regards, Gabi _______________________________________________ volt-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.
_______________________________________________ volt-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.
