There may be a D(1)—D(0) phase shift in a planar configuration induced by intense magnetic fields associated with local SPP’s or just the B field associated with the catalyst in resonance with the lasers oscillating magnetic field.
Calculation of the dense phase binding energy would be instructive relative to the D(1) phase. Such a calculation may be possible for a planar configuration. Bob Cook From: Bob Higgins Sent: Thursday, November 05, 2015 7:59 AM To: [email protected] Subject: [Vo]: Evidence for ultra-dense deuterium I would like to see more discussion of Holmlid's evidence for existence of the ultra-dense deuterium D(0). >From my reading, I understand the evidence for Rydberg Matter (RM) particles, >and it is strong. This evidence is based on rotational spectroscopy of clouds >of RM particles - the "snowflakes" I previously mentioned. Because these RM >particles have such large electron orbitals (the Rydberg states), the RM >particle spectra is highly susceptible to electric fields (well known Stark >effect) and magnetic fields (Zeeman effect). In fact, the Stark effect is so >large, it can be used with RM to make tunable RM lasers. RM forms from many >atomic species, not just hydrogen isotopes. This RM is NOT dense, and even >sodium RM particles are detected in the Earth's upper atmosphere, some 80 km >high. Obviously, to float in such a thin atmosphere, the mass density of the >particles must be relatively low. Now we come to Holmlid's propositions. The first proposition is that RM can form in monolayers on a metal oxide surface. This is not too far fetched. One could easily visualize a self-assembling effect of the hexagons under the right conditions. Has Holmlid proved a continuous film? I haven't seen that evidence. In other words, the Holmlid surface condensed H(1) / D(1) as a continuous film could simply be isolated RM particles that have attached to the metal oxide surface. Holmlid's next proposition is the spontaneous switching on the surface of the purported D(1) film with 150 pm atomic spacing to the ultra-dense form, D(0) having 2.3 pm spacing. First, is Holmlid expecting us to believe that the entire surface film shrinks in lateral dimensions by a factor of 65? Even if such a state switch could occur, it would be unlikely to occur in the entire film simultaneously - I think it would rip itself into small islands. What is Holmlid's evidence for the 2.3 pm ultra-dense D(0) state? As near as I can tell, the evidence comes from the energy calculated from a supposed Coulomb explosion - I.E. sudden failure of the mechanism holding the atoms at such a small inter-atomic spacing caused by an incident laser. If such potential energy existed for Coulomb explosion, then there would be no natural means for even individual RM particles to switch to this state - I.E. how can D(1) RM particles spontaneously jump to a configuration having so much higher potential energy as D(0) is purported to have? So, how can Holmlid say that the cause of the measured ejecta atoms is Coulomb explosion? Could it not be that some form of energetic reaction occurred between the substrate, the D(1) particles on the surface, and the laser? Perhaps a LENR reaction? Somewhere, Miley and Holmlid parted theoretical company. I think that Miley may believe that the RM particles could be complicit in LENR, but perhaps he didn't buy into the ultra-dense hypothesis. Bob Higgins
