The other day, I noted the 1993 replication of Mills is available on the net, here:

http://hydrino.org/documents/final-report-nascent-hydrogen.pdf

There is another quality replication of the Mills effect, in this paper:

Mengoli, G., et al., Anomalous heat effects correlated with electrochemical hydriding of nickel. Nuovo Cimento Soc. Ital. Fis. A, 1998. 20 D: p. 331.

Unfortunately, I cannot get permission to upload this one. Let me quote the Summary and some of the Introduction, which describes some of the history of the claim:


Summary. The hydrogen evolution reaction at sintered nickel in H2O-K2CO3 electrolyte was investigated by electrochemical and calorimetric techniques. Hydrogen evolution was accomplished with surface conversion of Ni into fl-Ni-hydride, the extent of this reaction being strongly enhanced by temperature. Isoperibolic or isothermal calorimetry measurements show that electrochemical hydriding, especially at a temperature close to the boiling point of the electrolyte, is paralleled by anomalous heat evolution in large excess of electric power input. Electrochemically activated Ni electrodes, led in open circuit, keep on doing heat.

1. - Introduction

Although generation of excess energy by electrolytic reduction of light water at either nickel or other metal cathodes was claimed by Fleischmann and Pons in their 1989 patent [1] it was subsequently not verified. The first detailed study on the subject was that published two years later by Mills and Kneizys [2]. They found a power output several times exceeding the Joule power input during electrolysis with low current density of aqueous K2CO3 at Ni plate electrodes: no anomalous effects were observed with Na2CO3 electrolyte. According to Mills, exotic physics were involved, whereby hydrogen atoms shrink . . .

Noninsky, was the first to confirm Mills' findings through reliable heat loss differential calorimetry [3]. In 1992, Bush published new data on the H2 0-Ni system [4]. Excess heat was systematically observed . . .

At the ICCF IV meeting, Srinivasan et at [5] independently reported both excess heat and tritium generation during electrolytic reduction of aqueous alkali solutions at the Ni cathode.

In 1993, two works were published on the subject. The first, by Notoya [6] gave solid evidence of the thermal phenomenon: not only was the power output three times higher than the power input, but this level was attained in a few hours, so that calorimetric measurements were probably not affected by the errors and/or artifacts which may occur during long electrolyses. The above author used a small (1.0 x 0.5 x 0.1 cm3) sintered Ni cathode which sustained high current (0.5 A) with remarkable specific power production (1 W/cm2). Results were interpreted according to Bush's hypothesis.

The second work, by Ohmori and Enyo [7], investigated other electrolytes (alkaline sulfates and carbonates) and metal cathodes (Ag, Au, Sn) in addition to the H2O/K2CO3 - Ni system: anomalous heat effects were observed in most of the systems excluding H2O/Na2 CO3-Ni and H2O/Li2 SO4-Ni.

In 1994 Mills et al. [8] and Mills and Good (1995) [9] again published works on the calorimetry of H2O reduction at Ni. Having increased the scale of the original process, greater excess power (41 W, eight times the I x V total input power) was measured with K2CO3, whereas negative results were again obtained with Nat CO3.

In 1994, Focardi, Piantelli and Habel [10] reported that the interaction of subatmospheric H2 (500-600 mBar) with Ni at temperatures of over 200°C gave rise to large enthalpy release. Hydrogen was loaded into the Ni sample using electromagnetic fields and temperature/pressure perturbations: after a long period of induction the system evolved into a state in which heat (>5 W/cm2) was emitted and was steadily self sustaining for months.

The above literature, although not exhaustive, lists the most important contributions to this intriguing topic. . . .


- Jed

Reply via email to